Northech NT-EM250 End Matcher

The NT-EM250 is our automatic 10″ working width feed through end matcher. The feed through
design allows for simultaneously processing of both the tongue and groove end to two random
length parts upon a single tool stroke. This provides an extremely e{icient operation especially
when connected to an automatic defect saw

MAIN MOTOR HP: (2) 5 HP Motors
VOLTAGE, FREQUENCY: 230/460 Volt 60Hz
PHASE: 3 Phase
AMP REQUIREMENT: 19.5 / 39 Amps
1ST STATION: Tongue
2ND STATION: Groove
1ST SPINDLE: 7410 RPM Male 40MM Tongue
2nd SPINDLE: 7410 RPM Female 40 MM Groove
SPINDLE LENGTH: 5”
SPINDLE DIAMETER: 40 MM
SPINDLE RPM: 7410 rpm
FEED HP: 1 HP Machine Feed 1/2 HP Infeed Table
FEED SYSTEM: (4) Feed Wheels
DRIVE SYSTEM: Gear Driven
FEED SPEED RANGE: 80 – 400 FPM